Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a Meraki Z3 that does not seem to be broadcasting LLDP information on any of the access ports.Is LLDP supported on the Z3, and is it enabled be default?
Hello, I am trying to register a new VG450 to CUCM as a SIP Gateway. This is working as expected, but I also need to be able to register the same VG450 as SCCP and MGCP. MGCP is fine, since it uses hostname.domain, SCCP is NOT working as it uses the ...
I am trying to use Message shuttle to move messages from a UCXN 10.5.1 system to UCXN 12.5.1 system and when I use Message Shuttle the target connection just hangs at loading data icon. I can switch the source and target and the source always loads t...
Thanks everyone. I was running my PCAP from my laptop connected to one of the Z3 LAN ports. I have an application on my corporate laptop (RedSky My E911 Client) that relies on LLDP to discover the wired network it is connected to for E911 compliance...
I bounced the entire unit, I see my laptop broadcasting LLDP, but nothing sourced from the Z3. I am running firmware MX16.16, which shows "up to date".
rymikles,Is this enabled by default on the Z3? My Z3 does not show any LLDP data when running a packet capture. I have looked at the configuration page of my Z3 and I do not see anything close to LLDP or even specific port configuration settings li...
Nithin, Using the MAC from G0/0/1 has allowed me to add the SIP gateway successfully. I have two SIP analog endpoints registered and will be testing functionality later today. This works for my current client, as they have both G0/0/0 and G0/0/1 con...
