Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, We have a ASR903 running 16.09.04. We have 2x A900-RSP3C-400-S route processors installed, and hit an issue when we were migrating over to the 903 from our old core Juniper router. During the migration CPU was sitting about 95% constantly, on ...
Hello All, We have had an issue recently with a new 903 where the CPU was constantly at around 90-100%. It should be noted, he CPU went this high after we started migrating connections to it from our old core router, which ultimately caused us to rol...
Hello, Just looking for some clarity around a deployment we are looking to do for a customer. So Basically they are looking to put in FTD 1140's at multiple sites. We will be looking to configure sub-interfaces on this and then the usual ACL's etc fo...
Since upgrading to 3.6.5, every file analyse I do, comes back with the error 'Cisco File Analysis is currently unavailable [UPLOAD_FAILED]' I am seeing a lot of this on the community page, is this an issue with 3.6.5? It worked perfectly fine on the ...
Hello All,Hoping someone might have some information to assist me. I have a ASA 5585-SSP-10 pair running in context mode. It is version 9.8(2).We have a customer who wants to configure dynamic split tunnels. However we cannot complete the configurati...
Hi, We plan on doing an upgrade before our next attempt, we also plan on taking a much more structured approach this time to try and catch if there is a specific connection that we move that causes a spike. Thank you for the response.
Hi Gustavo, Thanks for that, that solved my issue I have one other question, with Dynamic split tunnelling, can we exclude certain public subnets? Or is it only DNS names? Our customer is trying to break out MS Teams traffic locally, and it seems t...
Hi, So we would need to upgrade to latest ASDM? Which is 7.13 if I remember correctly? From CLI I also dont seem to have the option dynamic split options:The only options I have are on the attached image.
Hello All,Hoping someone might have some information to assist me. I have a ASA 5585-SSP-10 pair running in context mode. It is version 9.8(2).We have a customer who wants to configure dynamic split tunnels. However we cannot complete the configurati...
