Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
The latest firmware for the RV320 posted Nov 17 as 1.4.2.17. I just downloaded and attempted to update to one of our bench RV320's running 1.4.2.15. After it uploaded to the router, it kicked back a dialog saying bad firmware.
Re-downloading resulte...
In the Security > IP Source Guard tab of the RV340 (fw 1.0.01.17) selecting 'sort' either up or down does not work to sequence IPv4 Addresses.
That's also true for the DHCP Binding table sort for IPv4 Addresses under Status-and-Stats > DHCP-Bindings
...
Setting up customer RV340 - needs to use PPTP VPN with Win10 VPN service.
When configuring PPTP Server tab, set start and end IP addresses to a small range within an unused group of IPs in the scope of the working subnet. Regardless of where I try ...
We set up a RV340 with latest FW (1.0.01.16). Since we're using dual wan we need to pay attention to the failover address and use dynamic DNS (DDNS) aliases to do so.
When entering a DDNS FQDN, we found two problems:
1) The DDNS entry "fails" wit...
We just got in a couple RV340's from distribution to install at customer sites. As long time Cisco partners using RV320's for a long time we are looking forward to the 'new' model and feature adds. But, puzzled with the timezone selection as it's n...
We've seen a very similar scenario with several multi-AP setups with 581 ... latest fw. Also 350-series "ample" powered PoE+ switch. Latest location has 6 APs and have to put the last two on PoE+ injectors as the 350 switch shows dropping link on one...
We have version 1.4.2.17 running at customers and our own shop and have had zero problems after the Cisco re-posting of this version. Suggest you contact TAC with specifics. We are running with failover mode and it works just fine and no hangs.
Chet...
It appears Cisco re-uploaded the .bin fine for 1.4.2.17. It "does" load now.
The correct RV32X_v1.4.2.17_20171030-code.bin shows 35,628-KB size.
The earlier upload size was 26,282-KB.
Good catch and comments by others on this thread!
Would have bee...
Wow. Great to hear I'm not going crazy--- that setup should work as it does on the RV320's... which we've used now for years with PPTP under the active LAN subnet. That is the way I'd (and you'd) expect to access remotely the primary LAN the RV340 i...
Please offer some reference or example to correctly set this up then?
You see my pix and it's the same range set by yours? The primary RV340 LAN subnet is 192.168.75.0/24. We do this same PPTP VPN set up on RV320's all the time to access network d...
