Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I have a problem with a UC560 and SPA525G handsets. When the the DND softkey is pressed it is not showing up on the screen as activated. It also fails to show on other users phones that are watching the phone via the primary number.To complicat...
Hi,I have setup WEBVPN with the SSL client on a Cisco 2811. The WebVPN gateway is via a loopback address on the router, so I NAT port 443 to this address as it enters the ADSL interface.Everything works great apart from when I try to access an intern...
Since upgrading our core 6509 to a brand new 6509 sup720 we have noticed some strange Receive Errors on a number of interfaces. These interfaces all share common characteristics - they are all access ports, connecting to identical switches.The errors...
What version of IOS is required to run TACACS+ on a Cisco 2924-XL ?The device has 4 mb of flash which restricts the image I can use. I have upgrade to Version 11.2(8.10)SA6 which I thought had TACACS support but after reloading I cannot find any TACA...
Thanks for the response David. I am surprised at your comment though regarding the age of the firmware. The phone load 7-4-6 is part of the UC560-8-1-0 tar which has only just been superceded by 8.2.I am currently downloading 8.2 for the UC560 to ex...
I have now changed to a static IP address with my provider.I reconfigured the WebVpn gateway to be the WAN interface and allowed https on the same interface.The SSL VPN is still working great apart from when I try to connect to interfaces directly co...
I had the exact same problem apart from my router was a 2811.The Cisco SSL VPN client is not supported on any flavour of Vista - you need to upgrade to the Anyconnect client. I used the anyconnect-win-2.3.0254-k9.pkg I also found that SDM did not rec...
I was already thinking along these lines as the old 6509's were running hybrid with sup1a's and MSFC 1 cards. CatOs was version 6.3As part of the upgrade we migrated to running native.If this is the case - ie it's new functionality in the code pickin...
