Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have taken over an install and have come across some issues:CS and RME LMS2.2 were installed. When trying to install CM, the install tries to stop the dmgtd process but apparently fails. I then tried to install LMS 2.5 ontop of this but have the...
Gday,I'm having some issues with creating a regular backup schedule.I can succesfully backup immediatley but when trying to schedule a daily backup, i get an error saying "cannot schedule". File permissions are good:drwxrwxrwx 2 casuser casusers ...
Gday,I have a small request and that is how to change the senders email address when an email is generated from RME etc. For DFM, this is done from notifications. LMS is using the email address specified during installation. So I only need to change ...
Good day,Hopefully someone can point me in the right direction. I have an environment that contains many different devices and approx 2000 devices. I have discovered approx 1/3. Looking at DFM(ver4 Solaris), I have many devices in the questioned stat...
G'day mates. Hopefully you could give me some advise. I am at a customer who had LMS 2.5 installed and the server died. No-one could find the media until recently. This is all on Solaris. My problem is that the OS is 2.9 (which is required for LMS2.5...
Hi, No, my customer reported that it just “stopped”. You can disable the CSA if it continues. My concern was PSTN toll fraud, but there are ways of preventing this, which is what I did to put my mind at ease. Sorry couldn’t help. Regards Pieter
I found that it depends on how long you want each event to be recorded. So if you trigger an event at 12:00, andmotion detected is set to record for 30 secs after the event, an event at 12:00:15 will not trigger as a motion. Besides that, we found th...
Yeah,The last I did it was on Vsom 6.2. Configured the event, then disabled it to complete the configuration, then lastly enabled it whcih seemed to work.We found any version prior 6.2 was waste of time with motion recording.Good luck
Hi,NTP is crutial to IPCCTV. Set the camera's to oint to NTP server and use the video overlay to insert the timestamp in the video stream.Also need to point the VSOM server to an NTP source.RegardsPieter
