Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, Cisco controller is associated with one Cisco Prime infrastructure but now controller need to be associated/moved to another different Cisco Prime.What need to be done from controller side to disassociate with old Cisco Prime to add in new ano...
Hello,We have to change stack switch number. Could you someone provide proper steps .**Current conf **sh run | in proviswitch 2 provision c9300-48pswitch 3 provision c9300-48pswitch 4 provision c9300-48pSwitch# Role Mac Address Priority Vers...
I have seen OID for system memory (CISCO-MEMORY-POOL-MIB) , (1.3.6.1.4.1.9.9.48.1.1.1.5)but I need OID value to monitor the switch platform processor memory utilization. SWITCH#sh processes memory platform sortedSystem memory: 7750428K total, 4744660...
Hello Team, Will ISSU support on DNAC Version 2.3.3.7-72328-HF5.We tried to upgrade 9407R switches with ISSU its successful. But some switches not successful.I see some cisco documents stating that ISSU not supported on DNAC version 2.3.3.7-72328-HF...
Yes, As per document its not supported.we tried to upgrade C9407 from 17.6.5 to 17.9.4a. we got below error. Activation got failedISSU Status : Failed, Current State : Aborted.Reason : Mismatched Command List detected, remove these unsupported confi...
Hello, Thanks for sharing. I have checked and i see all access, trunk ports outputs are getting. I need to check only the interface UP/Down status where the port configured as Point to Point configuration (routed port). Only Routed port need to chec...
Hello, Thanks for sharing. I have checked and i see all access, trunk ports outputs are getting. I need to check only the interface UP/Down status where the port configured as Point to Point configuration (routed port). Only Routed port need to chec...
