Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
greetings everyonethis is about an issue i am facing with my Cisco 2960x switches. i did a firmware upgrade from 152-7.E10 to 152-7.E11 image which currently is the recommended one.Unfortunately for some strange reason, after reboot the switch goes i...
Greetings,The current version of my FMC for VMware is v7.0.5 build 72 with FX-OS V2.10.1 build 1400.I am planning now to proceed with the upgrade of FMC. Which version you would recommend for me to proceed with? Do i need also to upgrade FTDs with th...
GreetingsHave a general question. Do the Cisco FTD 2110 devices support configuration for password complexity settings such as minimum/maximu lenth, upper/lower case letters, special characters or lifetime of the password? Can this be done through FM...
Greetings,I have set the command "login block-for 300 attempts 3 within 60" on my network devices. However, i am aware that in case of failed login attempts then all users will be unable to login to the device for 300sec. Can somehow this command be ...
eetings,Could the community inform me about the following scenario please.I have 2960 series switches and i would like to do log retention for at least 1 year locally to the switch.How could i achieve that (without affecting switch performance) eith...
i tried to rollback to the old version but not possible either. Also it seems that for some reason the MAC ADDR variable has been deleted as shown on the output.
