Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
For NAT process, i've forwarded NAT required traffic from access interface to VSM with help of ABF. Packets generated by subscriber can reach to destination after NAT process but return traffic doesn't get routed to subscriber interface from vrf.
S...
Trying to deploy BNG with ASR-9010. Configured BNG with minimal configuration. Subscriber gets connected, receives both v4 & v6 IPs but data plane doesn't work. Cannot ping to subscriber from BNG and vice-versa.
"show subscriber session all" shows th...
Radius server send access-accept message but BNG is not providing IP to client. [ Using free radius and XRv9000 6.4.2 | 192.168.6.89 is NAS & 192.168.6.80 is RADIUS server. Looks issue is with radius configuration. IPSubscriber without RADIUS works f...
Receiving following syslog message:
*May 6 08:01:34.407: %ASR900IM-3-INVALID_COMBINATION: 8x10GE IM is not allowed in bay 3, can be supported only in bay(s) none
I'm trying to tweak routing table in inside vrf as return traffic comes to outside vrf and then to inside vrf.
Suppose a subscriber gets ip 10.0.0.10, if I add static route to /32 destination like config below in inside vrf NAT works perfectly fin...
XRv9000 didn't support "encapsulation ambiguous dot1q {any | vlan-range }". I've used this command several time in BE interface on a physical A9K routers while configuring PPPoE BNG.
Changing access interface from main interface to sub interface worked. Also "encapsulation ambiguous dot1q" wasn't applicable. Couldn't debug outputs of "show route, show cef, show cef internal". Outputs are as follows
Before:
--------------
RP/0/R...
Added "default-router" option in dhcp profile and sent 1000 packet with timeout 0. Result is negative. Didn't find any increment in interface counter.
RP/0/RP0/CPU0:vBNG#show subscriber session all
Tue Aug 21 10:13:07.033 UTC
Codes: IN - Initializ...
