Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a question about the cisco SD-WAN licensing model.I know there are several tiers (0-5), and for example the Tier 1 gives 200 Mbps nominal and 400 Mbps aggregate bandwidth.How can I monitor/detect/calculate if I'm reaching a license limit? Will...
Hi,I need an overview from all the access points and the assigned PoE (Power Status).Due to sometimes bad cabling an AP is running on Medium PoE, but there is no warning (except flashing color leds).I have tried it with: show ap config general | incl...
Hi,I'm trying the following setup:So I only want vlan 999 between Switch B and Switch C, but spanning tree is blocking vlan 999 on it's end. Since vlan 999 is not in the trunks between A&B and A&C and do not understand why it's blocked.Can someone ex...
Hi,Lately I'm experiencing a huge traffic drop when adding a static route (MX250).When adding, after a few seconds, uplink traffic goes down and stays down for more then 10 seconds.This results in other Meraki's getting disconnected on the site to si...
Hi,I installed Jabber 12.0.1 and when I want to send an screenshot to anyone I'm getting the "This screen capture could not be delivered" message.I used this article: https://collaborationhelp.cisco.com/article/en-us/WBX88448And installed the certifi...
Noticed a topic for packet tracer, that it would only work if the switch was reloaded.Tried, and now all the links are up and it works as expected, thnx anyway!
Might be some limitation within packet tracer (I'm trying to simulate first before putting it in prod.) but according to packet tracer: Spanning tree enabled protocol rstp