Good day all,I've been doing some testing and investigations and came upon this output that I cant quite explain. The output below shows the "Show interface switchport" output for a particular interface on my Nexus 3000 series switch.According to the...
Hi all,First time poster here. Hoping to benefit from your insight.I have a test environment with a hub and spoke architecture using OSPF as the routing protocol. Each spoke and the hub connect to each other over two simulated service provider WANs w...
@Giuseppe Larosa I thought about that. My issue though is that if the link goes down there wouldn't be a dynamic which over to the available link.This is why I want to adjust the cost so that in the even of failure it will dynamically use the next ...
Hi Guiseppe, I tried clearing the ospf process before but unfortunately it didn't work. I am also aware that the change will not propagate to neighbouring routers. Thanks for the reminder.
Interesting,Could it be a bug within GNS 3?Here's the output of the command requested below. Base Topology (MTID 0)OSPF local RIBCodes: * - Best, > - Installed in global RIB* 192.168.11.0/24, Intra, cost 1, area 0, Connectedvia 192.168.11.4, GigabitE...
