About ahalwani

ahalwani · 11-30-2010

Hi,I have a router configured with ip sla icmp echo to track some ip addresses in order to make some routing decisions.However, although I can ping the IP addresses just fine from the router with the correct source interface, their corresponding ip s...

ahalwani · 10-31-2013

Dear Wilsion,Thank you for your response, it was very helpful and thank you Alain for the inbound addition As you explained, the IP Source Guard solution will not be complete without the DHCP snooping.However, I forgot to mention that clients are ass...

ahalwani · 10-25-2013

Hello Wilson,I have 500 ME 3750 switch with multiple clients on the same VLAN per switch (About 4-7 clients on each switch).What is the best way to secure these ports so that no client is using another one's IP address?Port security is out of the que...

ahalwani · 10-25-2013

Hi,I know it is an old post but I faced the same problem and I couldn't restart the router.However, I noticed that I had a lot of pat translations so I cleared all nats (clear ip nat tr *) and that resolved my problem.HTH-Ahmad

ahalwani · 11-30-2010

A temperature threshold is exceeded if any of the following conditions occur:•The internal temperature of the router is over 100° C.•The internal temperature of the AC power supply is over 100° C.•The internal temperature of the DC power supply is ov...

ahalwani · 11-30-2010

you don't need MPLS a simple tunnel is enough

Member Since	‎11-16-2009 02:52 PM
Date Last Visited	‎08-18-2017 03:50 AM
Posts	6

User Statistics

User Activity

IP SLA Probe Failing

Layer 2 Security on Cisco Catalyst Platforms

Layer 2 Security on Cisco Catalyst Platforms

running-config

Re: what is the minimum temperature for cisco devices

Re: MPLS Configuration on Cisco 1841 Router