Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi everyone, hope you can give me your opinion about this.Have a customer that is being adamant that he wants MacSec enabled between the switches (Catalyst 9300), now the switches are connected to each via two Siklu Radios 80Ghz that provide 10Gbps.I...
Hi all,
hope you can help me.
I've been having an issue with OSPF that unfortunately I can't seem to figure it out. I have the following design:
Where if I disconnect VLan 5, I stop seeing Switch 2 (all switches are 9300). I can see that in the sw...
Hi all,
hope you can help me.
I have system running where I want to use multicast. The system is a CCTV system and the network is as per below:
Basically it's a ring running OSPF between Catalyst 9300 and the two catalyst 9300 to the right have Acce...
Hi everyone,I'm a little confused with the Cisco licenses that I hope you can elucidate.I have a network with Cisco Catalyst 9300 where two have the Network Advantage and 5 have the network essentials license. The network is running OSPF with around ...
Hi all,Hope you can help me.Have a network comprised 8 switches, where two of the cores (Switch 1 and 2) are connected to each other doing HSRP. In case on goes the other one take over. Also have this two cores connected to an Edge router to connect ...
Hi @pman Thank you for the reply.For what I see the replay protection will allow the link to accept out of sequence packets, but the weird is I'm having out of sequence packets in the testers but no packet loss. Replay protection automatically drops ...
Finally @Leo Laohoo I think i discovered what the issue is and for sure I should have stated this before. The system is running MacSec the switches are connected from switch to switch with the radios in the middle forwarding the packets. But if the r...
Thank you @Leo Laohoo I'll do that, and also at the same time I'll disable the pause frames from the radios, because curiously the radios are sending pause frames, but if they are disabled the radios continue to transmit without dropping packets. Thi...
Hi @balaji.bandi @Leo Laohoo , finally I can update this thread after several months since only now we could find the source of the issue. Even after updating the IOS the issues were still present. This switches connect to Siklu Radios and this siklu...
