Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Brothers,
I have a query regarding the FTP connections behaviour in Cisco FTDs.
We have allowed TCP/21 (& few others TCP/80, TCP/443, TCP/22) in a rule from a specific source to destination for FTP traffic.
But after allowing this TCP/21, I can...
Hello Team,
The ASA version is not matching in 1k FTD HA pair running FTD software.
Device Model: FTD 1120Version: 7.0.1
**We are getting the following warning:************WARNING****WARNING****WARNING********************************Mate version 9.16...
Hello All,
From the Book 'CCIE and CCNP enterprise core ENCOR 350-401' page 234, There is a statement as follows:
"NOTE A common mistake with summarization of IPv6 addresses is to confuse hex withdecimal. We typically perform summarization logic ...
Hello All, I have been trying to set up PortChannel(using 2 ports) to ESXi vSwitch from Cisco Catalyst 3560G-48T and the connectivity is not coming up if I set up the Portchannel in Access mode. If I shut either of any interface I can reach. No probl...
Hi @Rob Ingram , Thank you for the reply.in Both FTDs, the software version is same as 7.0.1 (build 84) as you can see in the screenshot below.
I am not sure this kind of behaviour. Please enlightem me how to match those.
