Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I need to configure on a cisco catalyst 6509 two VACL. On cisco 6509 there are already two SPAN ports configured, there are problems configuring other two VACL?These VACLs send traffic to a Traffic Analyzer (SIEM), there are particular configurat...
Hi all,I would like to ask you if it's possibile to block routing between some Vlan for just once of them.Maybe I can explain better:I've got a Cisco 6509 with 4 configured vlan interfacesInt Vlan 10 10.10.1.0/24Int Vlan 20 10.10.2.0/24Int Vlan 30 ...
Hello, I have to configure two ACS 1113 ver 4.1 (4) high reliability, in two different places and two different subnets. An apparatus will have to manage an office, the second the other office, but if one goes down the other takes responsibility for ...
Hi all,I've followed this guide https://supportforums.cisco.com/docs/DOC-1860 and I was able to get from a cisco device the "running-config" using SNMP.I need to know, however if is it possible to get the output of other specific commands like "sh ip...
hello, my company asked me to verify which authentication protocols are supported by acs 5.3. We have a network composed of all cisco devices, the oldest is a 2950 with IOS 12.1. I know they were compatible. ACS 5.3 up to what degree of backward comp...
Hi all,thanks for your answers.I would like to ask you some questions:1. In this way the WWW access will be blocked too?the Gig0/1 on the 6500 device is connected to a FW with a point-to-point.configuration 6500......int Vlan 100 desc --- link inside...
Thanks for your answer,I want to ask you two last questions: my two ACS servers are connected to two different Active Directory (synchronized between themselves) and in the ACS are defined only the account profiles. 1. Is it a problem that the ACS ar...
