Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Greetings -Is it possible to integrate the Meraki Z3 teleworker gateway with a non-Meraki MX at the head-end? Perhaps a Cisco NGFW2130?I am assuming "no" but I figured I'd get the official answer here.Cheers,Joe
Greetings -I have been working with Meraki products for over 6 years now (in IT over 20 years) and I have never done anything with APIs. I would love to find out more information on the topic but not sure where to start.If anyone can assist this old ...
Greetings -I have a scenario where a customer has two campuses - main and branch. The main campus has a primary 4GB Internet connection via a non-Meraki firewall and a backup Internet connection using business cable modem with a Meraki MX used here. ...
Greetings.I see that Meraki MR access points now support iPSK. I also saw a configuration example posted using FreeRADIUS and Cisco ISE but I was wondering if there was anything available for configuring iPSK with Microsoft NPS posted anywhere.Any in...
The reason for this post is to retrieve some information on how to go about configuring a QoS policy for LWAPP/CAPWAP.Currently, we have a 'hub-and-spoke' topology with one hub location and six spoke sites. Each spoke site has a 100Mbps link through ...
@jonas@complit.be - I saw this in the release notes for the beta firmware last week and I am looking forward to trying this out. I hit a brick wall with the iPSK w/ Microsoft RADIUS config attempt (running into the same issues that others have posted...
@cwf At this point I just need split-tunneling on the Meraki Z3 side. It's for a couple of 'work-from-home' colleagues.Thank you for the information/link.Cheers,Joe
@cwf Yes, that is what I was referring to. I saw the option for the Meraki MX AutoVPN feature but was wondering if it would support VPN tunnels with a non-Meraki MX appliance.CheersJoe
@Daniel Jensen I am in the same position you are but I was using Windows Server 2012 R2.I was also able to get MAB to work but the Tunnel-Password attribute would not be accepted by the clients. I was going to try using the Cisco-specific attributes ...
@Daniel Jensen I ran into the same issue. I was using NPS on Windows 2012 R2. What version of Windows server are you using? I was thinking of trying Windows Server 2019 to see if any updates to NPS features/functions were done.In the meantime I am wa...
