Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am trying to setup multicast over GRE tunnels between a pair of Hub routers to a spoke router. These are connected over an MPLS network that does not support multicast. The requirement is to have unicast work normally via MPLS and use CE to CE GRE ...
I am trying to setup multicast over GRE tunnels between a pair of Hub routers to a spoke router. These are connected over an MPLS network that does not support multicast. The requirement is to have unicast work normally via MPLS and use CE to CE GRE ...
Hi FriendsI am trying to setup multicast over GRE tunnels between a pair of Hub routers to a spoke router. These are connected over an MPLS network that does not support multicast. The requirement is to have unicast work normally via MPLS and use CE ...
Yes Shivlu. But it does not matter since I am only looking to solve the RPF failure issue which is local to the spoke router. It is expected that RPF check for RP address 100.64.0.209 should point to the Tunnel100 interface but it is failing instead...
