Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Is moh supported over sip trunks for cme 4.1 or later? I had multicast moh working internally but it won't go out over the sip trunk, I removed multicast moh to switch to unicast moh but there is no moh internally, I removed the multicast moh comman...
Need some help here, I cannot see what I am missing, I am working through the example on Route Foundation Learning Guide book, p800, four routers, R1 running RIPng, R4 running OSPFv3, R2 and R3 redistributing between RIPng and OSPFv3. Routing tables ...
We an 887m router in our office with an unmanaged switch. We have two networks, 192.168.0.x and 192.168.11.x connected to router on the same interface (192.168.11.253 is a secondary ip) but I can seem to be able to route packets from one network to t...
securityk9 None Smart License NoneSmart Licensing Status: UNREGISTERED/No Licenses in Use
I would address these two first. Register the device via smart licensing
Also, accept the end user license
Router(config)#license accept end user agreement...
I am not aware if you can pull that information directly from the CLI but I would be looking at logging out to a syslog server with a good reporting front end or some similar solution.
For anyone else having the same issue, I ran in to this also. After entering in the key in to the EirgpAuthKey text object, it wouldn't apply in the config, a default of "cisco123" was being applied. What I had to do was edit the flexconfig object ...
Thanks, your a superstar!! I had seen that in an ine video once before but forgot about it when I actually had to lab it out. Thanks for taking the time to look through that.
