Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all, Suddenly our incomming ISDN calls stopped to work. In the caller side I can hear a long ringtone and after a while I receive a busy signal; on the called side nothing happens(no ringing)I attached the debug output (q921,q931) can anyoane he...
Hi, I recently have started to study the MARS capabilities, and there are a few things which I don't understand. 1. What information should contain the Dynamic info in the device information window?I have set on equipments the snmp rw communities, sy...
Hi all,I'm confronting with a disconnect signaling problem on a cisco voice gateway.I have tried to use the Tone-based Supervisory Disconnect but there is no predefined cptone for our country. I have received these values from our voice provider:DIA...
Hi, I have one router connected to 2 ISPs. One of the ISP is used for Internet connectivity&VPN with branch office A and the other for VPN with a branch office B. The IPSEC endpoint on this side is an ASA, which is behind of this router. (See the at...
Hi all, I use cme4.1 with 12.4(15)T4 IOS.After I set some translation profiles and rules for separate accounting purpose (shared call manager between 3 companies with separate voice ports) the full-consultative transfer stopped to work. When I want t...
Unless you have some device in the HO wich does layer 5-7 inspection of the traffic there is no point to send the Internet traffic there. There is no difference in the protection offered by an 501 or an 515 pix.
Hi Marco, You can use the command below to restrict ASDM access.http xx.xx.xx.xx 255.255.255.255 LANOnly if you configure the ASA for NAT, otherwise you would end up in the same situation.Oszkar
Check out this link for the capture command: http://www.cisco.com/en/US/docs/security/pix/pix63/command/reference/c.html#wp1053548If you put back the original config you should see traffic coming from 172.16.38.0 255.255.255.0 and leaving the PIX 51...
In that case your pix515 config looks alright. If you do a show crypto ipsec sa on the 515 do you see the encap/decap counters incrementing? Do you see anything on the logs of pix 515 when you initate an nternet connection from behind the 501 subne...
Right, I missed your default route on 515 going towards the inside interface.Do you want to do the NAT on 515 for the networks behind 501 or you have a NAT device after the Catalyst sw which can/will take care of the NAT.
