Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all !I have in a branche office a WAE-274 connected by console to the auxiliary port of Cisco 1700 router.My question is how can i manage the WAE by telneting to the router ?Thanks for your help.
Hi all , One of my WAVE-274 has this alarm :CMS status is offline.It appears offline on the central manager GUI but it is reachable by Telnet . This is the message I get when logging :System Initialization Finished.Disk based software not installed.S...
Hi all, Although all the edges and CM have the same ntp configuration , I still have this major alarm on three Edge-WAAS even after synchronization .Is it possible to learn more about this - what caused it, ect.Any ideas on how to proceed? (software...
WAVE-274#sh disk detailsPhysical disk information: disk00: Present WD-WCAT1D394405 (h00 c00 i00 l00 - Int DAS-SATA) 239421MB(233.8GB) disk01: Not present or not respondingMounted file systems: MOUNT POINT TYPE DEVICE ...
I set the clock manually close to the CM time on one WAE and effectively the alarm disappear.Is it mandatory to re enable the ntp configuration ? I think if i do this the alarm will rise again .Thank you
Hi , I set the CM as ntp server for one WAE and set the calandar update .After reload and waiting some time the alarm is still present .Moreover this same alarm appears in a fourth WAE.
Excuse my english , i'm not native speaker .Alarm doesn't disappear even after 24 h from the synchronization .These are the outputs of commands entered in the same time on the WAE and the CM :Output on the WAE :Edge-BrancheOffice#sh alarmCritical A...
