Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, I have three FTD 6.6.1 managed by FMC 6.6.1, all three are the mesh topology.I got the following error message: Tunnel Manager failed to dispatch a KEY_ACQUIRE message.Probable mis-configuration of the crypto map or tunnel-group. Map Tag = unk...
Hi,I have FTD and a FMC, all of them have the 6.6.1 version.I have three sites, siteA, siteB, siteC are in mesh topology. I configured AnyConnect VPN for the main siteA.But I couldn’t move the Remote Access VPN setup to the main site (Site A) and con...
I have an FTD 6.4 managed by FMC.The problem I have is that the internet is very slow and the website pages don’t load at all but when I set the DNS as e.g 220.x.x.x on computer the internet connection works very well/fast without any problems.PC int...
Hi, We want to replace old firewall with one new FTD 1140 device managed by FMC 6.4.0.Our network has Switch HP Aruba 2530 with two VLANs (ex. VLAN110 and VLAN150). We created a sub-interface ex. (interface 1/2.150) on FMC, but didn’t work, it doesn'...
Hi Scott,thank you for your answer. NAT exemption is there on the SiteA, comunication between all three ftds as well Anyconnect works very well. But I got some time this error.object network NET-RA-VPNnat (outside,outside) dynamic interface Look here...
SITE B : Hardware: FPR-1010, 2935 MB RAM, CPU Atom C3000 series 2200 MHz, 1 CPU (4 co res):NGFW Version 6.6.1!hostname FTD-MVZenable password ***** encryptedservice-module 0 keepalive-timeout 4service-module 0 keepalive-counter 6namesno mac-address a...
