Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Im having a UCS server with 18 disks. Im trying to put 2 of them in raid 1 (for boot) and remaining disks separately in raid 0. I was trying to do this via LUN but I'm getting an error message stating. In the disk group configuration policy, I choose...
In the above set up if i give sh ip route for 10.242.0.0 in router A, I get the below output where the metric is 5. Any clue how its 5?COGINCHNTCOCORE#sh ip route 10.242.0.0Routing entry for 10.242.0.0/16 Known via "ospf 10", distance 110, metric 5,...
- in frame relay interface dlci command do we spcify the remote end pvc's DLCI or the local interface DLCI. Does this have anything to do this local and global DLCI addressing. I learnt that when a frame travels across the frame relay cloud the DLCI ...
I have two firewalls in 2 different locations. They act as primary and secondary for my WAN connectivity. I would want a way to synchronize access-lists in both without manually replicating.(access list, NAT and Route) FW model cisco 5580
Issue Resolved
The below step was followed
Verify
Before applying Service Profile to the server, make sure that the disks used in Disk Group are in "Unconfigured Good" state, else error stating insufficient disks will occur during service profile ass...
Sorry Im not allowed to share the complete configuration. Hope the below configurations help. Since rotuer 2 is PE I dont have its configuration ROUTER 3:!interface Vlan4 ip address 10.241.3.1 255.255.255.0 no ip unreachables no ip proxy-arp endrout...
