We have an H.323 Voice gateway. Any Inbound calls are not working. However, Outbound calls are working.   Am not able to see any Debug voip ccapi inout logs for Inbound calls. Below is the input for debug ISDN q931  000480: *Feb 12 14:53:05: ISDN Se0/1/0:23 Q931: RX <- SETUP pd = 8 callref = 0x090A Bearer Capability i = 0x8090A2 Standard = CCITT Transfer Capability = Speech Transfer Mode = Circuit Transfer Rate = 64 kbit/s Channel ID i = 0xA98381 Exclusive, Channel 1 Progress Ind i = 0x8283 - Origination address is non-ISDN Calling Party Number i = 0x2183, '5148077078' Plan:ISDN, Type:National Called Party Number i = 0x80, '5200' Plan:Unknown, Type:Unknown 000481: *Feb 12 14:53:05: ISDN Se0/1/0:23 Q931: Received SETUP callref = 0x890A callID = 0x0063 switch = primary-ni interface = User 000482: *Feb 12 14:53:05: ISDN Se0/1/0:23 Q931: TX -> RELEASE_COMP pd = 8 callref = 0x890A Cause i = 0x80AA - Switching equipment congestion show voice dsp group all DSP groups on slot 0: dsp 1: State: FW_DNLD_FINISHED, firmware: 23.8.0 Max signal/voice channel: 16/16 Max credits: 240 num_of_sig_chnls_allocated: 16 Transcoding channels allocated: 0 Group: FLEX_GROUP_VOICE, complexity: FLEX Shared credits: 240, reserved credits: 0 Signaling channels allocated: 16 Voice channels allocated: 0 Credits used: 0 dsp 2: State: UP, firmware: 23.8.0 Max signal/voice channel: 16/16 Max credits: 240 num_of_sig_chnls_allocated: 11 Transcoding channels allocated: 0 Group: FLEX_GROUP_VOICE, complexity: FLEX Shared credits: 240, reserved credits: 0 Signaling channels allocated: 11 Voice channels allocated: 0 Credits used: 0 dsp 5: State: UP, firmware: 23.8.0 Max signal/voice channel: 16/16 Max credits: 240 num_of_sig_chnls_allocated: 0 Transcoding channels allocated: 0 Group: FLEX_GROUP_CONF, complexity: CONFERENCE   show voice call summary PORT CODEC VAD VTSP STATE VPM STATE ============== ========= === ==================== ====================== 0/0/0 - - - S_OPEN_PEND 0/0/1 - - - S_OPEN_PEND 0/0/2 - - - S_OPEN_PEND 0/0/3 - - - S_OPEN_PEND 0/1/0:23.1 - - - 0/1/0:23.2 - - - 0/1/0:23.3 - - - 0/1/0:23.4 - - - 0/1/0:23.5 - - - 0/1/0:23.6 - - - 0/1/0:23.7 - - - 0/1/0:23.8 - - - 0/1/0:23.9 - - - 0/1/0:23.10 - - - 0/1/0:23.11 - - - 0/1/0:23.12 - - - 0/1/0:23.13 - - - 0/1/0:23.14 - - - 0/1/0:23.15 - - - 0/1/0:23.16 - - - 0/1/0:23.17 - - - 0/1/0:23.18 - - - 0/1/0:23.19 - - - 0/1/0:23.20 - - - 0/1/0:23.21 - - - 0/1/0:23.22 - - - 0/1/0:23.23 - - -   show voice dsp group all DSP groups on slot 0: dsp 1: State: FW_DNLD_FINISHED, firmware: 23.8.0 Max signal/voice channel: 16/16 Max credits: 240 num_of_sig_chnls_allocated: 16 Transcoding channels allocated: 0 Group: FLEX_GROUP_VOICE, complexity: FLEX Shared credits: 240, reserved credits: 0 Signaling channels allocated: 16 Voice channels allocated: 0 Credits used: 0 dsp 2: State: UP, firmware: 23.8.0 Max signal/voice channel: 16/16 Max credits: 240 num_of_sig_chnls_allocated: 11 Transcoding channels allocated: 0 Group: FLEX_GROUP_VOICE, complexity: FLEX Shared credits: 240, reserved credits: 0 Signaling channels allocated: 11 Voice channels allocated: 0 Credits used: 0 dsp 5: State: UP, firmware: 23.8.0 Max signal/voice channel: 16/16 Max credits: 240 num_of_sig_chnls_allocated: 0 Transcoding channels allocated: 0 Group: FLEX_GROUP_CONF, complexity: CONFERENCE   sh version Cisco IOS Software, 2800 Software (C2800NM-ADVIPSERVICESK9-M), Version 12.4(22)T, RELEASE SOFTWARE (fc1) Technical Support: http://www.cisco.com/techsupport Copyright (c) 1986-2008 by Cisco Systems, Inc. Compiled Fri 10-Oct-08 00:05 by prod_rel_team ROM: System Bootstrap, Version 12.4(13r)T, RELEASE SOFTWARE (fc1) VGW uptime is 3 minutes System returned to ROM by reload at 13:01:42 EST Tue Feb 12 2019 System image file is "flash:c2800nm-advipservicesk9-mz.124-22.T.bin"   sh dspfarm dsp all SLOT DSP VERSION STATUS CHNL USE TYPE RSC_ID BRIDGE_ID PKTS_TXED PKTS_RXED 0 5 23.8.0 UP N/A FREE conf 1 - - - 0 5 23.8.0 UP N/A FREE conf 1 - - - Total number of DSPFARM DSP channel(s) 2   test voice driver      Select option : 16 DSP Keepalive Status Display: ============================= DSP 1 is not UP, State: 3, Keepalive Sent: 0, Skip 0 DSP 2 is Alive, State: 4, Keepalive Sent: 749, Skip 1586 DSP 3 Not Exist DSP 4 Not Exist DSP 5 is Alive, State: 4, Keepalive Sent: 1168, Skip 1169 DSP 6 Not Exist DSP 7 Not Exist DSP 8 Not Exist DSP 9 Not Exist DSP 10 Not Exist DSP 11 Not Exist DSP 12 Not Exist   test dsp device 0 all reset 000466: *Feb 12 14:44:55: %LINK-3-UPDOWN: Interface Foreign Exchange Station 0/0/0, changed state to Administrative Shutdown 000467: *Feb 12 14:44:55: %LINK-3-UPDOWN: Interface Foreign Exchange Station 0/0/1, changed state to Administrative Shutdown 000468: *Feb 12 14:44:56: %LINK-3-UPDOWN: Interface Foreign Exchange Station 0/0/2, changed state to Administrative Shutdown 000469: *Feb 12 14:44:56: %LINK-3-UPDOWN: Interface Foreign Exchange Station 0/0/3, changed state to Administrative Shutdown 000470: *Feb 12 14:44:59: %DSPRM-5-UPDOWN: DSP 1 in slot 0, changed state to up 000471: *Feb 12 14:46:00: %DSPRM-5-UPDOWN: DSP 2 in slot 0, changed state to up 000472: *Feb 12 14:46:03: %DSPRM-5-UPDOWN: DSP 5 in slot 0, changed state to up 000473: *Feb 12 14:46:14: %ALIGN-3-SPURIOUS: Spurious memory access made at 0x40E1A8C8 reading 0x8 000474: *Feb 12 14:46:14: %ALIGN-3-TRACE: -Traceback= 0x40E1A8C8 0x0 0x0 0x0 0x0 0x0 0x0 0x0 000475: *Feb 12 14:46:14: %ALIGN-3-TRACE: -Traceback= 0x40E1A8D8 0x0 0x0 0x0 0x0 0x0 0x0 0x0 ... View more

I have Left the Voicemail to user Voicemail. But I don't see the Voicemail Count increased in the Mailbox of unity connection. The user is also not seeing the VMI ON. not sure where my voicemail messages are going..?   07:34:15, New Call, CalledId=111211, RedirectingId=111211, AltRedirectingId=, Origin=16, Reason=8, CallGuid=229EB39F0DE54B94BF71CEAFC69FAF73, CallerName=, LastRedirectingId=1112, AltLastRedirectingId=, LastRedirectingReason=8, PortDisplayName=PhoneSystem-Pub-001,[Origin=Unknown],[Reason=Forward Unconditional] 07:34:15, AttemptForward 07:34:15, State - AttemptForward.cde!Dummy 07:34:15, Event is [NULL] 07:34:15, PHTransfer 07:34:15, State - PHTransfer.cde!LoadInfo 07:34:16, Event is [TrueEvent] 07:34:16, PHGreeting 07:34:16, State - PHGreeting.cde!PlayGreeting 07:34:16, Call answered if needed 07:34:16, Playing greeting for Subscriber: Festus Mainline 07:34:35, No DTMF received 07:34:35, Playing greeting for Subscriber: Festus Mainline 07:34:35, Event is [RecordMsgEvent] 07:34:35, State - PHGreeting.cde!VideoAudioCheck 07:34:36, Event is [FalseEvent] 07:34:36, State - PHGreeting.cde!CheckForPostGreeting 07:34:36, Event is [NULL] 07:34:36, State - PHGreeting.cde!RecordMsgCheck 07:34:36, Event is [NULL] 07:34:36, State - PHGreeting.cde!RecordMsg 07:34:46, Event is [NULL] 07:34:46, State - PHGreeting.cde!RunEditMsg 07:34:46, -->MessageEditing 07:34:46, State - MessageEditing.cde!CheckEditOption 07:34:46, Event is [TrueEvent] 07:34:46, State - MessageEditing.cde!PlayAfterMessageEditMenu 07:34:46, Event is [FalseEvent] 07:34:46, State - MessageEditing.cde!PlayAfterMessageEditMenu_Audio 07:34:46, Event is [HangupEvent] 07:34:46, State - MessageEditing.cde!SetHangupFlag 07:34:46, Event is [TrueEvent] 07:34:46, State - MessageEditing.cde!CheckMsgLength 07:34:47, Event is [NULL] 07:34:47, <--MessageEditing 07:34:47, Event is [NULL] 07:34:47, State - PHGreeting.cde!AfterMsg 07:34:47, Event is [TrueEvent] 07:34:47, State - PHGreeting.cde!DoHangup 07:34:47, Event is [HangupEvent] 07:34:47, Idle ... View more

Hi  I have a DID Range 6000 to 6999. I need to block any calls coming to 6751 from Gateway. 6751 should be accessed internally within Office. No External Calls should come to 6751. Please help to achieve this. ... View more

Hi  We have a remote site and phones are registered to centralised cucm. CUCM---->SIPTrunk-->CUBE(Remote Site)--->ITSP. Can we configure the SIP SRST fall back for this scenario..? to make sure the phone are registered to local cube router and make calls via local ITSP We have both SCCP and SIP Phones . Any documents would really help me, Thank you  ... View more