Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi.I've heard that if someone takes the current CCIE Wireless written exam prior to the February deadline, they earn credit or recognition for the 300-401 ENCOR. Thus counting towards CCNP and CCIE certifications.I have search Cisco website and I hav...
Hi. I'm looking at buying some catalyst switches off eBay for labbing purposes. I'm just wondering what the lowest end switches that will support ios 15 and IP Services. I'm thinking WS-C3560G-24TS-E, as I don't think WS-C3560-24TS-E will support ios...
Hi.
I have a trunked switchport (source) which is mirrored to an access switchport (destination). When I capture the traffic using Wireshark, I do not see any VLAN tags (vlan.id). Is this expected, as the destination port is an access port? Should I ...
Hi.As far as I can tell with Meraki the same tags can be used for multiple purposes. For example, I can use a tag to assign an SSID to an AP, as well as, using the same tag to assign a VLAN to an SSID which is then assigned to AP. I'd personally pref...
Hi.
I'm trying to research the following command:
debug dot11 d1 dfs simulate
Does anyone know if simulates a DFS event on an AP or does it more "emulate" a radar and send out a little RF pulse from an AP to neighbouring APs?
I'm looking for a way t...
Sorry I was replying to Seb when he suggested that I might need to tag the VLANs on my Mac. I do not need to take any VLANs on my Mac (running Mojave).
Hi.
I have tested using a trunk port and I can capture traffic from multiple VLANs with the vlan.id showing correctly. So I'm confident that it's not the computer.
Thanks.
Hi.Thanks for the reply. I'm not sure of the model as I'm not in front of itright now but it might be a 2960.Sounds like you might be right.What would happen if the encapsulation dot1q wasn't used? I could still seethe expected traffic, it just didn...
