Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,Cisco FireSight Manager + FTD Is there a way of adding/assigning a private address range to a geolocation? So that it can be used in an acl and also appear against a country in the reporting?For example assign 10.0.0.1 to United Kingdom.Thanks in...
Hi Guys,I have a bit of an odd issue which I hoped somebody may shed some light on.I have a 2960-S switch which is used by an engineer to build laptops; we have noticed a few issues with network performance degrading over time to the laptops once the...
Hi All,
I am quite new to networking and have been asked to pick between a 2960-X or XR.
Apart from the physical differences which are quite clear I have a question regarding the difference between IP Lite and LAN Base licensing which I am struggli...
I can see you create a new geolocation and select the relevant countries to base it on, but how to you assign IP addresses to the newly created Geolocation?
Hi Georg, Thanks for getting in touch, please find the CPU outputs below:I have tried changing cables (all are CAT 6), I will try a different model of laptop this weekend as we get them in batches so only have 1 model at the moment. Rm6-Cab11#show p...
Hi Alex,
Thank you for your reply, the Q & As were where my question really came from, in the chart for what is supported on what model it shows the XR supports IP Lite but has a no against LAN base.
So should I read that as the XR comes with IP Lit...
