Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, Everyone ! Warm greetings to you all. I have faced a problem middle of the configuration of Cisco SG350-28 Switch. Now i'm stuck ! The problem is ...."No more IP address could be added". In Detail....1. I have already added 2-293 VLAN with Di...
Component In My Network:1. Router2.Cisco SG 350-28 - L3 SW || Inter-VLAN Routing Here3. Linksys SRW224G4- L2 SW || Port Based VLANs here-24 Different VLANs and different subnet Need Best Solution :1. I want to access Printer from All different VLANs2...
I have one SG350-28 Manageable L3 and one is old Linksys SRW224G4 L2 Switch. So i configured 2 VLANs on L2 switch and assign the port fa0/2 as acces port and also define access vlan 2 for Vlan 2 and same for Vlan 3 on fa0/3 and G1 as trunk port and a...
Sorry For delay reply. I'm sorry It's done. I waited long time but i didn't get a reply. But finally it works.Thanks to u both. OK, My question was Router-on-a Stick between Mikrotik to Cisco L3 SW.1. Linksys L2 SW: Individual Port individual VLANs 1...
Thanks to you for rapid reply but in my office we have 700 PC , so if i do it manually. It's so.... . So there any option in L3 switch to accept this ICMP Echo Reqest and another question was switchport trunk encapsulation dot1q doesn't show in L3 Sw...
