About PH42420

PH42420 · 06-05-2021

I am re-configuring the SG500 in L3 mode, but have not had success accessing the internet on it. The current configuration is below, and is as far as Cisco Support and I got with the device last week. Arris Router Subnet: 192.168.0.x/24, Router Gat...

PH42420 · 02-07-2022

Hello, I wish I knew what he did, but the configuration he helped create was as described. It was in place for at least a year before I had to relocate. Since I have relocated a second time, I feel as though I'm at a sort of impasse. The SG500 is no ...

PH42420 · 12-06-2021

Sounds good. I will give that a try and let you know how it goes. I will just repeat one point for all viewing this thread. The Cisco engineer that helped set the device up long ago, with AT&T, did say that he was using PAT, Port Address Translation....

PH42420 · 12-05-2021

Sure... I had to copy and paste a question mark into the CLI. The terminal moves to a new line every time I attempt to enter "?" using "Shift"+"/".

PH42420 · 12-05-2021

I will take a look and reply with what I find. For now, this is the current output of that command: SG500#configure terminalSG500(config)#interface ge 1/1/12SG500(config-if)#no switchport% Incomplete command Best regards,

PH42420 · 12-04-2021

I've got the same problem as well. I have seen this done successfully, but a Cisco tech some years ago. Though, I didn't see how it was done. Best regards,

Member Since	‎07-26-2020 07:31 PM
Date Last Visited	‎11-10-2022 01:20 PM
Posts	20
Total Helpful Votes Received	30

User Statistics

User Activity

SG500 28P L3 Enabled - Internet Access Not Working

Re: SG500 28P L3 Enabled - Internet Access Not Working

Re: SG500 28P L3 Enabled - Internet Access Not Working

Re: SG500 28P L3 Enabled - Internet Access Not Working

Re: SG500 28P L3 Enabled - Internet Access Not Working

Re: Hello Jernej The "no