About shelzmike

shelzmike · 11-30-2021

I am using an older C220 M3 in a lab environment. I am not using any RAID cards and am only using the on board LSI MegaRAID with SATA drives. Clearly, a standalone installation. The frustration I have been having is that every time I have to reboot, ...

shelzmike · 07-27-2020

As we can all probably relate, I am at my wits end at this point with this setup. It is in a home lab, so nothing major, but it should be working. I cannot tell where my problem lies. I am quite familiar with Cisco, but mainly Catalyst and haven't re...

shelzmike · 12-11-2019

We have been having this issue for quite some time now, and I finally have time to actually pose the question here as I cannot come up with anything searching. On all of our 3750x's and some (if not all) of our 3650's, we have some port types that ha...

shelzmike · 10-14-2019

Working on a stack of new Catalyst 9200L-24P-4G switches. This is the first time with this model and am beyond frustrated at this point as none of the documentation seems to work. Currently, all 4: Switch Ports Model SW Version SW...

shelzmike · 12-02-2021

This is helpful info. In fact, it does tell me exactly what I need to do. Challenge is finding a older browser/flash/Java version that will allow me to do it. Thanks!

shelzmike · 07-31-2020

Yeah, it literally was a brain block. All of the messages that related to the RPi all have 117, clear as day now, but I literally could not see it! The contributing factor, I think, was the gateway being correct, but address being wrong. The gateway ...

shelzmike · 07-30-2020

Well, I figured it out (well, part of it at least, the biggest part. Haven't done other testing yet as there were a few other weird things on other VLANs).For VLAN 172:You know that saying, "Can't see the forest for the trees"? Well, that applies her...

shelzmike · 07-30-2020

I keep finding this message in the wireshark logs and I haven't quite figured it out. Meaning, I basically know what it is, but not sure why it is happening. Not sure if it is related to an actual issue, or if the issue is because the USG doesn't act...

shelzmike · 07-30-2020

So I tried your suggested test.I have a completely different VLAN (ID 2). Trunks are passing. USG doing DHCP. I have 2 fixed wire ports, both access VLAN 2.Connected, and immediately received IP addresses for both. 10.100.100.6 and 10.100.100.7.When ...

Member Since	‎10-14-2019 01:00 PM
Date Last Visited	‎12-09-2021 01:10 PM
Posts	24
Total Helpful Votes Received	15

User Statistics

User Activity

Is there a way to disable Cisco VIC when not needed on C220 M3?

Cannot get VLAN Working SG500 (L2) with UniFi USG (L3)

Massive quantities of DOT1X and MAB Auth errors on many switches

9200L - Can't convert from bundle to install mode. Commands are not recognized.

Re: Is there a way to disable Cisco VIC when not needed on C220 M3?

Re: Cannot get VLAN Working SG500 (L2) with UniFi USG (L3)

Re: Cannot get VLAN Working SG500 (L2) with UniFi USG (L3)

Re: Cannot get VLAN Working SG500 (L2) with UniFi USG (L3)

Re: Cannot get VLAN Working SG500 (L2) with UniFi USG (L3)