Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello
As I am preparing a CCNA Security, I would like to buy a used ASA on eBay. There are some between £100 and £200 with some VPN licenses.
One of my concerns, is the licensing. I don't want to buy something that would be essentially a brick beca...
Hello
The other days I did a Webex to help a customer to configure some vlans and add them to existing trunks.
Something surprised be but I didn't want to ask the customer.
In my lab equipment, if I am on the global config mode or under an interfac...
Hello guys,
This is my first post here. I created a multi-area OSPF topology with one particular area at the edge which I defined as "stub".
The stub router received a default route pointing to its neighbour but still its routing table showed all O...
Here is the output from my Router and you see it has vlans:
Main#sh ip int brInterface IP-Address OK? Method Status ProtocolFastEthernet0/0 192.168.100.254 YES NVRAM up downFastEthernet0/1 unassigned YES NVRAM administratively down downSerial0/2/0 u...
Hello
Yes, it's possible to have vlans on a router.
I have a router with a 4-ports L2 card (Cisco HWIC-4ESW). These ports are pure L2 ports. I can't assign IPs to them. If I go under the interface and I issue "no switchport", it's not accepted.
Howev...
Thank you! Yes, my area was totally stubby. I would have almost gotten away with a 0.0.0.0/0 route towards the single ABR but I needed to advertise connected networks.
I am going to read the document your shared.
