Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Experts ,4507 R switch ---- FW...Actually Vlans are defined on Nortel FW and servers are connetcted on 4507 R switch.I know that show mac-address-table | in mac address will show the port details on which server is connected..But in this scenario ...
Hi ,Is there any way to enable ip accouting on gig (EoSDH link is terminated between Site A and site B) of 4507 R switches...Site A (Gig 3/45) -- EoSDH link -- (G3/45)Site B.I want to analyze the traffic which is traversing through 10 Mb EoSDH link b...
Hi Experts ,Below is the scenario.(DMZ zone)--nortel FW-trunk link-4507R ---10Mb link----4507R.Vlans 11,31,16 of DMZ network are configured on Nortel FW.trunk link is configured between Nortel Firewall and 4507 R switch allowing Vlan 11,31 and 16 so ...
Hi Experts ,I would like to know the maximum number 2960 switches can be cascaded.How many 2960 swutches we can connect in cascaded position.Is there any doc.Thanks,Satish
Hi Jon ,Thanks for reply...As you said i need to find out which port that server is attached to on 4507R switch.I did following things..1.I got mac-addresses of servers from Nortel Firewall.2.executed the command "show mac-address-table | in server m...
Hi ,Vlan's are defined on Nortel FW and we are allwoing that vlan through trunk port of Switch...and servers are placed in respective vlan's on 4507 R switch.Ex : 4507 R switch Gig 2/1---Trunk port (allow only vlan 52)---G0/0 of Nortel FW.FW config :...
Hi Siddhartha ,Try with below config :interface Tunnel12description GRE tunnel between FHQ and Tekanpur ip address 192.168.11.2 255.255.255.0 qos pre-classify tunnel source Serial1/0 tunnel destination 10.10.90.1 crypto map VPN-slcinterface GigabitEt...
Hi sidhhartha ,directly connected interfaces will ping each other without any route or protocol...remove that default route pointing towards gig interfaces of other router.you must use cross cable for connecting gig interfaces back to back as both ar...