Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have an SG 200-50 that had firmware version 1.0.0.19 (the very first version). I tried to update the firmware to 1.3.7 and the boot file to 1.3.5 so I could then upgrade to 1.4.11. Now I cannot ping the switch after rebooting it. Sadly, this is the...
Following the instructions in this link to try to get a backup of my start up config:https://www.cisco.com/c/en/us/support/docs/smb/switches/cisco-small-business-200-series-smart-switches/smb2897-download-or-backup-configuration-file-on-an-sx200-sx30...
I got access to the building, did a hard power cycle, and the switches started working again. Perhaps the 7 minutes in the documentation was optimistic and I should have been more patient. Actually, I *should* have been more patient since I was upgra...
Ok, so console cable to the switch? Then what? What should I be looking for? Its been probably 20 years since I've had to program a switch, and I've never had to recover one. A little more background: I work in a food processing facility that runs 2...
Overheard during a C-level meeting:VP1: What happens if we train our employees and they leave?VP2: What happens if we don't train our employees and they don't?
