Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Firepower 1010 doesn't forward data over port 1/5 after successful upgrade from 7.2.5 to 7.2.6. It does see MAC address of a directly connected router but can't PING it. It can PING its own IP address on the port 1/5 though. It seems it can only IP c...
I have created the below network setup, trying to get VPLS running over GRE P-P tunnel. The GRE Tunnel is Up. MPLS seems working OK, I can ping from 172.16.18.0 to 172.16.160.0. However, VPLS comes Up (VC is Up) but doesn't forward traffic between si...
I use FTD (FPR1010) for VTI tunnels to remote sites. When I have 10 tunnels, they are all stable, however, as soon as I add new tunnel it works but flopping periodically. As more new tunnels are added, they flop more frequently. At the same time, the...
Does Cisco C1000 switch support the stacking similar to StackWise? The datasheet states this: "Single IP Management is available on the Cisco Catalyst 1000 Series switches. The uplink ports can be used to connect up to eight switches in a sigle stack...
This source suggests to disable STP on the VPLS router. I've tried it but failed. This warning might mean the hardware doesn't support BPDU through VPLS: % % Command rejected - BPDU pseudowire config not allowedI had the same on the real hardware (C1...
I'm very sorry, I've uploaded the wrong config. The below is the correct one. The VPLS allows HSRP to go through but not STP. When I try allow STP under VFI I get this:TLH-DSW(config-vfi)#forward permit l2protocol all% % Command rejected - BPDU pseud...
