About Mancunian

Mancunian · 04-16-2025

Disable access-session monitor explicitlyEven if device classifier is active due to ASP macros, you can try disabling just the monitoring.Avoid macro auto global processing on supplicantIf you don’t need ASP macros to run on the 9200CX supplicant swi...

Mancunian · 04-16-2025

Local vs TACACS conflict: If you're trying to log in with local credentials but TACACS is still the primary method, and it's not available or has expired, it may reject the attempt instead of falling back to local.TACACS server unreachable: The TACAC...

Mancunian · 04-11-2025

Agree with M02@rt37 , also, you do not need to reload the switch. But the change may reset traffic briefly as it applies the new MTU settings across ports. So it's best to do it during a maintenance window.

Mancunian · 01-30-2025

Please follow as suggested @Joshqun Ismayilov

Mancunian · 01-28-2025

vlan dot1q tag native command is typically supported on switches running Cisco IOS-XE, such as the Catalyst 9000 series. The Catalyst 1000 series runs a more basic version of IOS that does not include this feature.

Member Since	‎08-24-2018 10:31 PM
Date Last Visited	‎06-05-2025 01:23 AM
Posts	34
Total Helpful Votes Received	9

User Statistics

User Activity

Re: Catalyst 9200CX - 17.12.5 - dot1x supplicant controlled transient

Re: Switch local credentials are not working after removing switch IP

Re: Nexus 9000 Configure MTU jumbo frame

Re: Unable to ping default Gateway

Re: Catalyst 1000 Series: Enabling Native VLAN Tagging