Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have two sites, connected to client- A with 1G cable using ebgp. I am advertising 1.1.1.0/24 from both site to client-A. Site-1 has 1.1.1.1 and site-2 has 1.1.1.2 server. How can I choose shortest path to reach 1.1.1.1 or 1.1.1.2 ? (10.1.2.0/24 nat...
Hi,
I have receiver on Z side which is in my control and source on A side of the network, to which I dont have access.
I am getting routes using eBGP, now here is the issue -
I know the RP address and mcast groups A side is publishing but they are ...
Hi,
I am using ACS 5.8 version.
1. I can login to IOS device using tacacs local account and local privilege password, ButI have to enter "enable" command to get vty prompt. -> How can i directly goto global config mode ?
2. I have AD setup too, and ...
I am advertising 1.1.1.0/24. Cant advertise any other route. Otherwise this would work.
This is exactly my question is...if I am advertising /24, is there any way to do policy routing for specific routes?
Tnetwork design:
client-A
...
this is inbound traffic (lets say telnet from client-A to server inside, sorry i dint provide this info before).
local-pref and wight will work for outbound traffic. also, I am advertising 1.1.1.0/24, how can i set as path (prepend) for specific 1...
I had Max Priviliege level set to 15, but I changed Assigned Privileage Level to 0. I set both to 15, and it is working now. But initially I had both set to 15, and it dint work. I chaged so many other setting to make it work, so I dont know which ex...
