Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello friends I am in need of a help. I am currently working on a setup for a client. Topology is simple. There are 2 sites connected together over 2 P2P links. These are both layer 2 links. I recently replaced their EoL cisco 3500 switches ( 4 the...
Hello I am wondering if someone can help me. I have a Cisco 2802i which was running Cisco ME 8.3 and all was working fine, I have now upgraded it to 8.10 to see what features has been added ( had to do incremental from 8.2 to 8.5 and then 8.10). I...
AP is currently connected to the laptop directly. I connected to it this way before and it worked fine. I have done a factory reset by pressing the mode button for 20second and then starting from scratch! is there a command to manually enable a radi...
It seems that this is truly broken now! I have reverted all the way back to the 8.3 that it had on it and working, and it is still not working! I can't even get to the ME controller on the management IP address! I can ping it but no response to htt...
Hi Scott Hi Scott. yes I had a quick look and at 8.5 it was working fine. This is for my test lab, so not the end of the world if I can't get it to work. so might have to roll it back to 8.5 and work on it there,
