Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello all
I have 2 stacks of 2 C9300-48T-E switches.
We need to add extra 10GB copper connection using the SPF-10BaseG-T.
Which switch can I add to the stack to enable this?
Thanks
Glenn
Hello All
I was wondering in a VPC set-up could a Port-channel have normal vlans and pvlans running in the same channel?
Int Po215 have lines for vlans and lines for pvlans?
If possible how would that look as a config?
Hello All
I have FTD 2110 running ASA 9.14.1 in appliance mode.
Via Console port I connect to fxos admin and through to fabric but the commit-buffer command does not work.
I am trying to change the mgmt IP from default to a new static. Can anyone hel...
Hi All Just looking for an upgrade path for IOS-XE versions.Currently running 16.6.8 going to 16.12.7.Already know will have to move to Smart License that process is under way to convert our current license to a smart one ready for this.Just trying t...
Hello All
We have a switch stack that we connected too for the first time via console connection and they are stuck with justa ^> prompt
Tried to get into enable mode but normal cisco cisco123 passwords do not work.
Any suggestions?
As we are not i...
Hi, thanks.. we have Cisco SFPs that's not the issue. I'm looking for which switch model I can add to the current stack of 2 C9300-48T-E that will provide at least 8 10GB ports? this model only has 4 which are already in use. would a C9300X-24HX-E wo...
For information the port-channels are going from the switches to servers running VMs, so the pvlans are for backups and the other vlans are for normal DATA
Hi I have a similar issue, building FTD2110s on 9.14.1, trying to set-up the FXOS side as in IP address so we can manage the chassis as well as the ASA side yet commit-buffer command does not work in appliance mode. So 1) how do I configure an IP add...
Maybe not the same issue, pair of 2110 running 6.5.0.4, trying to upgrade to 6.7.0, readiness check - primary fails with Got Exception and secondary passes?Any ideas?
