Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi I have FTD 2110 configured with multiple VPNs I tried to monitor these VPNs using SNMP Server and it is ok all L2L IPSec VPNs are monitored, but I have one VPN configured as (Hub and spoke) I couldn't retrieve its status I am using SNMP OID (1....
HiI tried to configure Netflow on cisco switch WS-C3560G-24TS version 15.0(2)SE11 with ELK Stack (Elasticsearch, Logstash, Kibana) Netflow analyzer, but after I finished the configuration I didn't receive correct traffic the ELK receives NetFlow traf...
HiI have Cisco Firepower 2110 and I want to monitor VPNs I tried (CISCO-IPSEC-FLOW-MONITOR-MIB) it didn't work for me I tested it as shownsnmpwalk -v3 -l authPriv -u USER -a SHA -A "PASSWORD" -x AES -X "PASSWORD" 10.10.10.10 CISCO-IPSEC-FLOW-MONITOR-...
HiI have Switch C1000 Version 15.2(7r)E3I want to apply ACL, but I couldn't apply it on interface Vlan the configuration as shown C1000(config)#interface VLAN 250C1000(config-if)#ip access?% Unrecognized commandwhen trying to apply in the physical i...
Hi I have ASA 5515 configured with multiple VPNs I want to monitor these VPNs using ZABBIX I used the SNMPwalk command as shown, snmpwalk -v3 -l authPriv -u USER -a SHA -A "XXXXXXXXX" -x AES -X "XXXXXXXX" 192.168.15.12 CISCO-IPSEC-FLOW-MONITOR-MIB::c...
yes I configured the ELK as V9 and also yes tcpdump shows traffic coming from the switch, but as I mentioned in the beginning the switch sends the NetFlow for dropped packets only or sends fake traffic
Hi Balaji yes the ELK can reach this VLAN and this is the output of show flow exporterFlow Exporter elasti-exporter:Description: NETFLOW Export to elastiExport protocol: NetFlow Version 9Transport Configuration:Destination IP address: 10.10.30.100...
