Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have 12 routers and 23 switches that I need to ACS to manage. Is there a quick way to deploy AAA on all the switches and routers instead of going in each one and configure it? I am new to ACS, so any help on how to configure would be great.Thanks
I am a newbie to the Pix. I am trying to understand the running config list. The question I have is what does the command line mean:access-list inside-outbound deny tcp 10.1.2.0 255.255.255.0 any eq 135Does it mean deny TCP 135 traffic from outbound...
I have Cisco Catalyst 4510R with two VLAN. Vlan1 and VLan2. I have a remote site that have a cisco 2950 switch. The remote site is connected to us directly. I want to be able to configure three ports on the remote site switch to be on and communi...
I have several Aironet 1100 series APs and everything works fine. I would like to decrease the signal so it could only be reach in certain distance or area. Is there a way for me to do this?
I am new to this so is there a way for me to find if there is a trunk to switch 4510R. The remote site is connect through a T1 internet line and traffice goes through Pix 515e.Thanks
Michel,Thanks for your reply but I do not wish to configure or install a proxy server. I want to find if someone who is not authorize to setup a proxy, setup one on the network.
