Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HUB tunnnel: bandwidth 16000 ip address 10.0.6.9 255.255.255.248 no ip redirects ip mtu 1400 ip nhrp authentication xxx ip nhrp map multicast dynamic ip nhrp network-id 1 ip nhrp holdtime 600 ip tcp adjust-mss 1360 delay 1000 tunnel source FastEthern...
Hi, I have following configurationmls qos!class-map match-all cm-int-test match input-interface FastEthernet1/0/23!policy-map port-test class cm-int-test police 256000 48000 exceed-action droppolicy-map vlan-test class class-default service-...
Hi,On catalyst I have one L3 (no switchport) interface, which is connected to ISP router (12Mbps rate-limit on ISP router).On catalyst is configured some VLANs (cca 6) with public IPs. For example:30.0.0.0/30 - ISP interface 30.0.0.1 - ISP default GW...
Hi,here is a sample config:interface FastEthernet0 ip address 1.1.1.2 255.255.255.252 ip nat outside ip virtual-reassembly duplex auto speed auto no cdp enable!interface Vlan1 ip address 10.0.1.2 255.255.255.0 ip nat inside ip virtual-reassembly!ip c...
THX a lot...do you have any examples for solution 3?and what about solution 2? I saw some tutorials, where router modifies the DNS reply for internal ip address... but not for routers (only PIX) :o((
