Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,I do not have the command "failover lan unit secondary" in the configuration.But still i see the pix box shows as secondary.ph-md-pix1# show failoverFailover OffCable status: NormalFailover unit SecondaryFailover LAN Interface: not ConfiguredU...
Hi Experts,If there are multiple sub interfaces and vlans are created with different security levelsWill the traffic flows from high security level interface to low security level interface?.What is the case if we have the acls in place?Thanks in adv...
Is there any commands to forward the traffic comming from one interface to the other ?The switch I am using is a Layer-2 4506 device..and I can not enable the routeing...Thanks in advance.
Thanks kwu2 for the information.I wanted to conncect a cross cable between them.can i configure lan based active/standby configuration using failover cable ?.Thanks,Madan.
Already there is a route with the permanent and distance of 1If i have the second route with high distance value.Being the first route with the distance of 1 and having permanent parameter will the second route be taken if the next hop is not reachab...