Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Cisco Family, good day. I have a nexus 3064pq-10g-x with the current software level on version 6.0(2)U6(7). I'm facing an issue that I plugged the GTC-T transceiver on the cisco nexus switch but it is not operating on 1G, ports are showing the sta...
you need an active partner-level/customer-level support subscription in order to download, although some old firmware is now free from cisco. Let me know which switch you are looking for. Regards
Hi The following error is occurs after removing the speed and configure it on manual; " Configuration does not match the port capability " The issue remains the same. Best Regards
full-duplex, 100 Mb/s, media type is 1GThis is because I set the speed on 100Mb/s, meanwhile here is your required outputs Switch#show versionCisco IOS Software, C2960 Software (C2960-LANBASEK9-M), Version 12.2(46)SE, RELEASE SOFTWARE (fc2)Copyright ...
One more thing I want to mention that, it's operating on 1g with server and SAN on the other end, but whenever I give the uplink to cisco catalyst 2960 it shows this behavior.
Hi Balaji Thanks for your response. I already perform the mentioned exercise, but the issue was the same. meanwhile please have the output of the suggested commands; sh run int ethernet 1/38!Command: show running-config interface Ethernet1/38!Time: S...
