Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi I recently purchased a few 240ac APs and mesh extenders to replace an existing WAP321 deployment. Unfortunately my experience has been pretty bad so far with them and I am hoping its just my lack of information. I have done the initial setup and...
Hello all - I manage a small business with 6 locations. I currently have numerous access points at these locations and all AP's are Cisco WAP321's. Instead of continuing to buy these EOL APs I decided to go with the new 240AC's and use the mesh ext...
Alright the mystery has been solved, thank you pieterh for the help. Here is what has happened and it will no doubt affect others. I had looked everywhere in the access point (primary) and I never saw what was listed in the document above. The pro...
I have taken a look in the full manual as well and I cannot find anything about setting a static IP other than during the initial setup. Would greatly appreciate if you could provide a page number or link that you saw it. I must be missing it somew...
I appreciate your feedback however that Quick Start Guide doesn't say anything about configuring the IP address after the initial setup. If SSH is not supported then why do they give you an option to turn it one in the Management section? And if its...
I am not sure what I missed but when I first configured the AP I wasn't able to connect via HTTPS to the IP address to manage the AP. This is why I begin to incorrectly assume that I needed to use the management interface. I just tried again today ...
