Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Side note... wont cdp only show directly connected cisco devices??? if the routers are all connected to a L2 switch why would any be cdp neighbors... wouldnt they be neighbors of the L2 switch, which in this case is a 3COM...
to create tunnel between sites you need to use public addresses assigned by ISPYou can not create a tunnel between sites using 10.x.x.x or 192.168.x.x etcI believe there is a way to use the asa 5505 as termination and use DDNS and outside address pro...
How about L3 P2P links from access to core and a routing protocol to provide load balancing and redunancy ?? A properly configured routing protocol will provide better convergence times than STP and will alow for true load sharing....
