Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi mates : )I am trying to understand multicasting. It is IP based (Layer 3) soo looks i need a layer 3 device for multicast traffic. Can i realize multicast communication without routers?i'll appreciate if you can answer the below questions ;1. Lets...
hi mates pls see the attached figure i draw for you shows my network.- Location A and Location B is working OSPF right now without any problems.- we want to add a new WAN node(C) but they want computers to have the same network ID on two WAN nodes (...
how do we understand if routers are load balancing the data transmition?Configuration:there are 2 routers (A and B)at the center and 2 routers (C and D) are at the remote site.A is connected to C (E1)B is connected to D (E1)OSPF is the routing protoc...
hi mates I'll really appreciate if someone can help me about enabling diff-serv on 4503 switch.- we have hosts directly connected to 4503 switches.- packet priorities are set on the hosts according to rules defined in diff-serv. (bits are set in IP ...
hi mates I'll appreciate any help about below described problem;Customer asked me to implement QOS on his 4503 switches.- it is a simple Layer 2 network without VLANs. - two 4503 switches are connected to each other using etherchannel- some computer...
ty for your fast response but i am not sure if that solves my issue.lets say there is a pc with 192.168.10.1 on location Bandthere is a pc with 192.168.10.2 on location C,how can router 2 understand which IP belongs to B, which IP belongs to C and se...
hi joseph thanks for replying2 routers at the center are connected to each other via a multilayer switch, OSPF is running on that switch too.for router A and B (routers at the center); output of #show IP route , shows both paths. in this case can i ...
