Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I got a project for the first time toget some clusters operational overseas1 that is coming up very soon is TokioJApan'I was wondering if there is a website out there that tell you like for each country what is the digits for local callslong distance...
I have a gateway with 10 PRI"S but the network select only allows a maximum of 8what other way can i configure the remaining 2 pris's so I dont experienceslips.
what happens if one channel on a PRI is set to maintenance.i ran a debug on one of my cisco voice gateway terminated 4 pris and users were experiencing fast busy when trying to call outbound.... Channel ID i = 0xE9808397 Exclusive, Interface 0, Cha...
We had an issue that some users where experiencing intermittend fast busyi ran a debug and saw this message. I suspect that some channels where out of service.... any one seen this?Change Status i = 0xC1 - maintenance Called Party Number i = 0xA1, ...
I have an issue and wondering if someone has seen this. I have two phone on a conference room IP phone cisco 7961 and a analog phone using the same extension. The analog device is hanging of a vg224. We i use the cisco phone and make a call it works ...
what i experience before that the same pris going to the same telco we were expericing slips it was not until i enable the network source clock that it fixed it. therefore i am nervous to leave it out and have some issues.
This t1 will be configure for voice only no data so configuration might look likecontroller T1 5/0 ds0-group 0 timeslots 1dial-peer voice 1000 pots destination-pattern 1000 port 5/0:0Now you mentioned a signialing type how would i know what signaling...
