Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a router that I would like to config as a "ftp-firewall" That means I want to allow just ftp-trafic to-and-from a network to a ftp-server(10.1.1.5).What would that config look like?I have maybe done something wrong bacause when I take a "dir" ...
I have a server with ip 10.2.1.4 in a network 10.2.1.x .I want to get to that server from another server 10.2.15.2 .Why is this not working???This is my config on the 2611xm-gateway:=================================interface FastEthernet0/0 descripti...
Hi!I have a network with only 2 2924 connected together so I get 48 ports. The problem: The network was getting slow and it stopped for a while, then it was OK for a while. Up and down. Then I replaced the 2 2924's with a simple 3com and then it was...
I want to build a network - private network. I have 80-90 sites with up to 14 hosts on each site. The hosts comunicate with a server. Not much trafic. Can I use a couple of 2924-XL-EN to connect the sites together? And from the switches a connection ...
Hi!Sorry for the late response. I've been out of office...The equipments on the far end are stuff that sending hello-messages. Not much trafic. A PC maybe from time-to-time.The far end are places outside the company office(CO). We use those modems fo...
OK, I have some 2600-routers that I think I can use.But can you please look at the attached plan and tell me where I should put the router(s)?And maybe you have a better plan?The 10-net is up and running today. I want to create the new network withou...
Thank you for your answer!I have a small network with 2 cisco 2924. I would like to use those for 2 diferent networks because of line cost. Just private networks. Could I have a 2900 in one end?Kenneth
I've been reading these contributions and have a question :Is it possible to skip the router and just carry on with just switches? And the 2 vlans of course...Kenneth
Hehe!Yes, I figured it out. Don't know where my head was I'll try the config tomorrow. Seems like a good solution.Thank you so far! I'll let you know if it's working.Kenneth
