Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a site-to-site tunnel terminated on an ASA 5520. I have syslog logging to an internal server, and I have setup a syslog server on the other side of the tunnel. I have created my acls for interesting traffic and I cannot get the ASA to send t...
Ran into an issue trying to allow for passive-ftp on an ASA 5520. I have enable the ftp mode passive, even went so far as to allow an "ip any" to the FTP server in the DMZ and disable the global filtering policy. The client will connect, but cannot...
I have a PE-P-PE setup. I am able to receive routing and IP information pertaining to the MPLS VPN that I am trying to create. Inside the VPN, I cannot ping from PE subinterface to PE subinterface. Anybody have similar issues?
Could CRC errors on an ATM interface be from a rate-limit that is set too low (compared to the amount of normal traffic that crosses the link) causing the interface to occasionally drop cells containing the EoM 1?
The problem I am having is not from passthru, it is from device origin going across the tunnel. I have provided a quick visio to help explain this request.
If you are good at what you do, there will always be a job for you. I think the real question would be, "do you enjoy networking?". If the answer is yes, then I would go for it.
1. In addition to failover, 7.0 supports statefull failover.2. As long as you have proper memory, then both boxes should be able to run 7.0. Once upgraded and configured, either one can be used as primary, your choice.3. For failover to work, bot...
If you are talking about the stackable management cable, then only the 3700s have the stackable technology (for now). If you are just wanting to trunk, then yes they will work.Hope this helps.
Cisco Press has three books that are really good:MPLS and VPN Architectures: Volume IMPLS and VPN Architectures: Volume IIMPLS Configuration on Cisco IOS SoftwareHope this helps.
