Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all, in order to do any troubleshoot in firepower FTD 6.4, but at this point any version, in which sequence are these 3 things executed? NAT/Routing/FW rule Thanks Davide
We have 2 DNAC Active/Standby and the witness, the witness is located to a sort of third Data Center.All 3 DataCenters have access to the MPLS through a dedicated PE.The witness has two way to reach DNACs:1) Using a dedicated DWDM link which directly...
Hello, after deploying a couple of firepower of 4100 family, we configured the FXOS in cluster, apparently there is not differentiation on between cluster and HA (unless I missed something). So far so good, the problems comes when from FMC I want to ...
Hi, I am relatively new to FMC, I know tnat CIMC is for management of the hardware of the server fan and so on,my question is, is it possible to assign for instance inband network to mgmt0 and OoB network to mgmt1? is it wise to use the same OoB netw...
Hi,4 FTDs in cluster HA Active/Passive should be added to 2 FMCs Active/Passive. FTDs are 4115.I am perplexed on deployment of standby FMC, if it has to be aware of FTDs or not, I just now that passive FMC don't do any actions as long as active FMC i...
Thanks for the informative answer Marvin, in that case I assume HA and cluster is differentiated also at the chassis level (FXOS).The two firepower 4115 are directly connected using portchannel 48 with a single physical interface assigned to it, the ...
Thanks very much Joachims, regarding the 4 interfaces:CIMC interface (labeled "M")Serial console porteth0 (labeled "1")eth1 (labeled "2")would the CIMC be the equivalent of OOB (Out Of Band) Interface, whereas eth0 and eth1 are for HA, mgmt and so o...
