Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
# Network EnvironmentNetwork camera (connected wirelessly) <-----> Wireless Access Point <-----> Windows 10 OS PC (connected by wire)The Wireless Access Point is PoE.The model number of the Wireless Access Point is: C9130AXI-Q (Cisco EWC software ap1...
# Network EnvironmentDevice A (connected wirelessly) <-----> Wireless Access Point <-----> L3 Switch <-----> Device B (connected by wire)The L3 switch and Wireless Access Point are connected by wired.The Wireless Access Point is PoE.The model number ...
Hi, I'm currently setting up my "C9200-24PXG-E (Essential License)" in our office.My target/goal is to use this L3 switch and control the exit to the WAN, by isolating the default gateway for each VLAN. For example:Devices that has IP of 192.168.111....
Hi, Im trying to deploy 2 C9115AXI-Q.But somehow, as I connect them to the network, both has the same IP address and hardware address. The output of show interface via terminal is below:GigabitEthernet0 is up, line protocol is up
Hardware is EWC ma...
Hi, I'm currently trying to setup 3 C9115AXI-Q in our office.I have set different SSID to each devices. However, once I connect 2 device together within the network, only 1 device becomes active.On top of that, the setting from device #1 is transferr...
@Mark Elsen Thank you again for the suggestion. I have tried updating my AP to the newest version as you have mentioned. Sadly, the issue still exist.I still could not stream the video feed from my network camera to the PC which are both connected t...
Thank you for the input @Mark Elsen I have tried to disable the "Fast Transition" but the issue still exists.Our network security camera cannot send its streaming data to our PC.I have also checked the log from AP while "Fast Transition" is disabled...
@Mark ElsenThank you for the input.I have connected to the AP via ssh and input the "show logging" commandto check the logs while I tried streaming to the network camera.However I do not see any logs that might give me a hint the issue that I am curr...
Thank you for the suggestion @Mark Elsen.I will check the logs, but I have some few question about it.How should I check the logs? Should I connect the AP to my PC using a RJ-45?Or is there a way to check the logs using the Web UI?How can I check the...
Thank you for the kind reply @Georg Pauwen There were some questions from the other users about my problem,so I have added more details about the issue in my original post.(you can refer to it for more information) Regarding your comment, we have alr...
