Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,I have two AP 1240s at a site, both with the same firmware and configuration, and all users are configured correctly to connect to the network. AP 2 is having some type of issue that is not allowing a complete connection to some of the users....
I am wanting to troubleshoot the last week's log on a AP, but it only shows 12 hours. What is the config I need to run to save the logs from the last restart to a file on a server?Thanks for any info.
Hello everyone, I posted this in General Forum first, but i wanted to hit this group as well.On an AP1200, can you set up two different SSIDs on a radio interface using two different types of encryption, without using vlans? I am trying to use WEP fo...
Hi again,On an AP1200, can you set up two different SSIDs on a radio interface using two different types of encryption, without using vlans?I am trying to use WEP for the data side(i know, still waiting on the wpa go ahead) and wpa2 on the voice side...
Hello all.I have been doing upgrades on APs in our network and one of the AP1200 units had firmware 122-11.JA3 loaded. It would not take the http upgrade, so I loaded 123-4.JA2 via tftp. The file actually made it all of the way onto the Ap without ...
Sorry for the delay. The end solution was that the switch was set for a smart port that was configured to only allow a device with three users on it. Therefore, three users connected fine, and any subsequent users were dropped. So configuration of...
So the problem was that the switch that the AP was connected to had a configuration on it that caused the AP to only authenticate three users. It was a 'smartport' configuration that gave us the problems. Thanks for your time and efforts on this is...
Thanks again for your time and persistence. I do run all autonomous APs and have only cli management interface. We haven't moved on centralized management yet.The users are not failing authentication...the radius server shows no failures and the AP...
Thanks for the quick response.The laptops that have issues connecting to AP2 cannot connect no matter what their distance from the AP. Constantly getting a 169 ip when connecting to AP2, that is until they roam away and connect fine to AP1.The RADIU...
