Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,Switch# show platform ip unicast counts
# of HL3U fibs 2426...... PL explain # of HL3U adjs 4.... Pl explain# of HL3U mpaths 0....Pl explain
# of HL3U covering-fibs 0... PL explain# of HL3U fibs with adj failures 0 .... Pl explain
Fibs of P...
Hi ,In Existing switch i am unable to find running configuration of the vlan number 1000.but sh vlan and sh vlan brief its showing active and some port are assinged.other than VLAN 1000 ,all inteface vlan configuration and l2 vlan name I am able to ...
Hi All, Is CMTS7225(UBR7200-NPE-G1) require any license for activating CMTS feature and line cards(U7225VXR-M28EUG1)? Because I am not able to configure ip address for cable interface . CMTS(config-if)#ip ?Interface IP configuration subcommands: dhc...
Hi,Router A and Router B(3845) connected with 50 mbps point to point ethernet link.Router A(interface) shows the bandwidth 49 mbps but routerB shows only 25 mbps.what would be the problem ?Thanks.,
Marconi,>>>>>Did you try to associate the cable interface to a bundle, and configure the IP in the bundle?When we do two or more physical interface configration ,bundle is required.But i am using single cable inteface ,Still i have to use bundle co...
>>>>>>1. Did you mean that your throughput/ 30 sec rate is not matching on both the routers ?This will not be same unless until its a symmetric traffic like icmp.Ok.Thanks,>>>>>>>>>>2. There are errors in counters as shown in the attachment starting ...
